Manual

Command Reference

46 Beijer Electronics, MAEN993

5.6.18LAU_CONFIG_SETSTARTUPBRIGHTNESS

MODE (0x01A4)

Startup Brightness Mode

The Beijer Electronics RBCs can be configured to start with different levels of bright-

ness. There are four modes for the backlight at startup:

• Backlight is off

• Backlight has the same level as before it was turned off

• Backlight starts with the default brightness, which can be configured as well

• Backlight is on with maximum brightness

Supported since Firmware Version

LAUER RBC: 0.0.0.1

Command Stream

Response Message (Acknowledge)

Note:

The changes made by this command will become active only after a restart of the de-

vice.

0 1 2 3 4 5 6 7...9 10

0x07 ADR 0x4C 0x41 0x55 0x03 ICHKH 0x01 0xA4 Param ICHKD

Param

Value: 0x00: Device starts with minimum brightness (normally

backlight off)

0x01: Device starts with the same brightness as before it was

turned off

0x02: Device starts with default brightness

0x03: Device starts with maximum brightness

Type: Byte

Length: 1

Description: Set the mode of the backlight at startup

0 1 2 3 4 5 6 7 8

0x06 ADR

0x4C 0x41 0x55 0x01 ICHKH Ret ICHKD

Ret