User Manual

Command Reference
Elektronik-Systeme Lauer, MAEN976 131
6.73 LAU_STATUS_ANALOGTOBRT (0x030B)
Current Analog to Brightness Routing
Mode
Returns the current state of the analog input port usage. The analog input port usage
can be modified using the SCOM command
“LAU_CONTROL_ANALOGTOBRT” or digital input.
Supported since Firmware Version
MT223 NAV-230G: 1.0
MT226 NAV-230G: 1.0-DSCALE2
Command Stream
Response Message (Acknowledge)
Response Message (Negative Acknowledge)
Under normal operation conditions, a device never sends a negative acknowledge in
response to this command.
Maximum Lr for this Command
9
Example
Check whether the routing from analog port input to backlight level control is en-
abled for the monitor at address 0.7 (group 0, address 7) is activated:
According to the data returned by the monitor at address 0.7 (group 0, address 7),
routing is currently disabled:
0 1 2 3 4 5 6 7...8 9
0x07 ADR
0x4C 0x41 0x55 0x02 ICHKH 0x03 0x0B ICHKD
0 1 2 3 4 5 6 7 8
0x06 ADR
0x4C 0x41 0x55 0x01 ICHKH Ret ICHKD
Ret
Value: 0x00: Routing from analog input to backlight level control
disabled
0x01: Routing from analog input to backlight level control
enabled
Type: Byte
Length: 1
Description: Current configuration of the analog input port usage
0 1 2 3 4 5 6 7...8 9
0x07 0x07 0x4C 0x41 0x55 0x02 0x0D 0x03 0x0B 0xDE
0 1 2 3 4 5 6 7 8
0x06 0x07 0x4C 0x41 0x55 0x01 0x0F 0x00 0xFF