Owner's manual

Command Reference
94 Beijer Electronics, MAEN975
6.54 LAU_CONTROL_ECDISMODE (0x0201)
ECDIS Mode Control
This control command activates or deactivates ECDIS mode. It has the same effect
as using the front panel ECDIS-key or digital input control. The setting is temporary,
and does not change the startup ECDIS mode configuration.
Supported since Firmware Version
MT230 Nautic Monitor: 1.0
Command Stream
Response Message (Acknowledge)
Response Message (Negative Acknowledge)
Under normal operation conditions, a negative acknowledge message does not con-
tain any status data in response to this command. This response message is only sent,
if there is insufficient data in the command stream.
Maximum Lr for this Command
11
0 1 2 3 4 5 6 7...9 10
0x07 ADR
0x4C 0x41 0x55 0x03 ICHKH 0x02 0x01 Param ICHKD
Param
Value: 0x00: Disable ECDIS mode
0x01: Enable ECDIS mode
Type: Byte
Length: 1
Description: ECDIS mode
0 1 2 3 4 5 6 7...9 10
0x06 ADR
0x4C 0x41 0x55 0x03 ICHKH 0x02 0x01 Ret ICHKD
Ret
Value: 0x00: ECDIS mode disabled
0x01: ECDIS mode enabled
Type: Byte
Length: 1
Description: Current ECDIS mode
0 1 2 3 4 5 6 7...8 8
0x15 ADR
0x4C 0x41 0x55 0x02 ICHKH 0x02 0x01 ICHKD