Technical data

brixlelektronik ...we got the solution
–bc-12er 12 channel receiver bc-20 plus 20 channel receiver
the stick movement
MultiplikatorP 0.2..2.00 Stick movement multiplied with MultiplikatorP is
[Multiplier positive] movement of the connected device(positive)
MultiplikatorM 0.2..2.00 Stick movement multiplied with MultiplikatorM is
[MultiplierM] movement of the connected device(negative)
Maximalwert -100..125% Maximum output value for the conncted device
[max. value]
Minimalwert -125..100% Minimum output value for the conncted device
[Min.value]
Schnelligkeit 0.01..100 Maximum speed of the signal change for the
[Speed] connected device. Controls servo/esc speed.
Übersteuern A-z Defines the input device for the overdrive option
[overdrive]
Überst.Multi -100..+100% Defines the % of the overide option. The overide
[overide multiplier] can be used in + or – direction and is defined as 0
when the module is powered up.
AusgangsSignal Puls Default setting for servos and esc
[Output signal] PWM1 A 0-100% PWM signal will be provided on this
output (to be used with bc-msII)
PWM2 -100%..+100% PWM signal will be provide on this
output (to be used with bc-msII)
Choosing PWM2 will also release the feature „PWM Erweitert“ [PWM extended] which will
only be uesd on the bc-msII. Please refer to the manual of the bc-msII for further details.
Funktion: Hydraulik [Feature: Hydraulic]
This feature will provide a hydraulic simulation with standard servos. The connected
device (servo) will only move as long as the coresponding input device is moved.
The connected device will stop when the input device is in neutral.
Senderkanal A-z Defines the input device of the tranmitter (Stick, switch, etc)
[Input device]
Einschaltwert Defines the position of the connected device when the module
[Default value power on] is powered up.
Gemerkt Last position of the connected device before
[Memory] switched off
kein Sig. No servo signal send to the connected device
[no signal]
23.06.14 Vxx417