Technical data

brixlelektronik ...we got the solution
–bc-12er 12 channel receiver bc-20 plus 20 channel receiver
IR = IR LED connector with integrated resistor
I = IR sender or receiver
D = Display
N = Multiswitch/Nautic Module
LED1 = Status LED
LED2 = Eeprom/Memory access
LED3 = Operation indicator
Installation
The modules must be connected with an antenna and must be supplied with the
supply voltage in the assigned range. Please refer to picture 1 and 2 for the correct
connection.
(Remark: the coded wire of the antenna must face outwards)
The antenna code must have been programmed in the transmitter as per the
instructions in the transmitter manual. Switch on the transmitter and the receiver
and connect them as per the manual. Once the connection is established the blue
LED on the tranmitter will light up and you can start programming the reciver.
Remarks
The texts and terms in the programming menues are german and can not be
translated by now. This manual will use the german terms as they appear in the
menues. The english translation willl appear in [brackets].
The term input device is used in the text for all devices on the transmitter that can
be used to control the model. Upon delivery the transmitter might be equipped with
different devices which can be individually configured. The standard configuration
contains sticks, 3 position switches, 3 position momentary switches and rotating
pots. An input device can be also connected to the receiver and act similar to the
input devices on the transmitter.
The term output device is used for all actors in the model which are connected to
the receiver. An output device can be a servo, ESC,PWM driver or an LED.
23.06.14 Vxx417