Technical data

brixlelektronik ...we got the solution
–bc-12er 12 channel receiver bc-20 plus 20 channel receiver
[Empf.konfig] Receiver in programming mode
[Funkabriss] Connection lost, receiver in fail safe mode
[geparkt] Receiver in park mode
Vers Version number of hard- (12) and software (417)
EinZ Module has been started xx times
BSZG Hourmeter total (HH:mm)
BSZ Hourmeter depending on a defineable input device. (HH:mm:ss)
Input device must be programmed in [Funktion: Status] Feature:
Status. This allows to start and stop the hour meter with the same
input device as a hydraulic pump to monitor operating hours. Hour
meter values will be stored onboard upon status change or every 3
minutes.(resetable)
The flicker effect shown by the display is an intended effect to visualize the
operation.
Funktion: Mischer [Feature: Mixer (only available in bc-20 plus)]
This feature offers up to 6 completely free programmable mixers (M1 to M6). The
mixers can handle up to 8 different input devices.
Ausgang 1-32 M1-M6 Chosse the mixer to be programmed.
[Output 1-32]
MischerFunk Addierer All input devices will be added and send to Mx
[Mixer function] [Addition]
MaxWert The highest value will be sent to Mx
[Max value]
Mischkanal 1-8 1..8 This input device will be programmed now
[Number of input device for mix function]
Eingangssignal A..z+M1..M6 This input shall be used. Using M1..M6 will link mixers
[Input device]
Totzone Pos. 0..95 Input device will not be used up to this value in positive
[Dead zone positive] direction
Totzone Neg. 0..-95 Input device will not be used up to this value in negative
[Dead zone negative] direction
Multipli.Pos -200..+200 Multiplier for positive direction
[Multiplier positive]
Multipli.Neg -200..+200 Multiplier for negative direction
[Multiplier negative]
23.06.14 Vxx417