Technical data

brixlelektronik ...we got the solution
–bc-12er 12 channel receiver bc-20 plus 20 channel receiver
Please note that no infrared receiver should be connected during programming. For
programming an antenna or a cable connection must be used.
Funktion: Display [Feature: Display]
A 0.9“ display can be connected to output 12 to visualize different values. It will
display the operating voltage and the values measured by connected sensors.
Senderkanal A-z Defines the input device of the tranmitter that will change
[Input device] the display content. (swap between measuring values
and hour meter). Momentary switch is recommended for
this option.
Screen content measuring values:
brixlcontrol
[status]
[mv1] [mv2]
[mv3] [mv4]
Akku: 12.0V (bc-20 plus only]
BEC : 5.04V
[status] can be either:
[Spannung EIN] Power supply on
[betrieb] Connected to transmitter
[Empf.konfig] Receiver in programming mode
[Funkabriss] Connection lost, receiver in fail safe mode
[geparkt] Receiver in park mode
[mv1..4] Measuring values as defined in [Funktion: Eingang Messen] Feature:
Measuring Input
Akku voltage of power supply
BEC voltage of BEC
Screen content hour meter:
brixlcontrol
[status]
Vers : 12417
EinZ : 12
BSZG 0:27
BSZ 0:23:15
[status] can be either:
[Spannung EIN] Power supply on
[betrieb] Connected to transmitter
23.06.14 Vxx417