Technical data

brixlelektronik ...we got the solution
–bc-12er 12 channel receiver bc-20 plus 20 channel receiver
modules wich are linked with infrared.
Please note that input voltages should not be higher than 3.3V. Add a 10k resistor
for protection purposes.
If an open collector output (e.g. brake lights from ESC) is connected to these
inputs, a pull up resistor of 5k to +BEC might be necessary.
Auf Kanal n-z n..z Which letter shall be assigned to this input?
[Channel n-z]
Gegenläufig NEIN 0V -125% ..>2V +125%
[Reverse] [No]
Ja/Invers >2V -125% ..0V +125%
[Yes/Reverse]
Funktion: Eingang Poti [Feature: Input Potentiometer]
A potentiometer can be connected to an input using bc-MM-Poti. The position of
the pot will be read and can set any letter from n-z with a value between -125% and
+125%. This letter can be used as an input for functions on the same moduel or can
be transfered to linked module via infrared or cable connection.
The pot value must be between 2.2k and 10k and will be used as a voltage divider.
0V =125% and +3.3V = +125%
Auf Kanal n-z n..z Which letter shall be assigned to this input?
[Channel n-z]
Please note:
Letters n-x will be transmitted via infrared to linked modules. Letters y and z will not
be transmitted. This will allow the usage of y and z exclusively on the module where
the coresponding sensor is connected. Please ensure the unique usage of the
letters on linked modules!
Funktion: Eingang Messen [Feature: Measuring Input]
This feature is used for telemetric purposes and will send new measured values
from the receiver to the transmitter every 400ms. Measured values can be also
displayed on the bc-disp on board display. Please note that this feature requires a
restart of the receiver after programming. Otherwise no data will be transmitted.
Messart Spannung25 Voltage measurement using the bc-MM-Sp sensor with
[Voltage25] the measurement range of 0..25.0V
Spannung50 Voltage measurement using the bc-MM-Sp50 sensor
[Voltage25] with the measurement range of 0..50.0V
Strom 10 Current measurement using the bc-MM-St sensor with
23.06.14 Vxx417