Technical data

brixlelektronik ...we got the solution
–bc-12er 12 channel receiver bc-20 plus 20 channel receiver
0 Neutral signal will be provided (1.5ms)
Ausschaltwert Defines the position of the connected device during park mode
[switch off value] (choosing and connecting to new model with transmitter)
halten Current position will be held
[hold]
kein Sig. No servo signal send to the connected device
[no signal]
+/- 125% Connected device will be set to the programmed
position
0 Neutral signal will be provided (1.5ms)
Funkabrisswert Defines the position of the connected device when the signal is
[fail safe] lost or the transmitter is switched off
halten Current position will be held
[hold]
kein Sig. No servo signal send to the connected device
[no signal]
+/- 125% Connected device will be set to the programmed
position
0 Neutral signal will be provided (1.5ms)
Lenkkanal A..z Defines the input device of the transmitter (Stick,
[direction] switch, etc) for the direction control
Lenkung Zugabe -100..+100 defines the increase of speed of the outer track
[steering increase]
Lenkung Abnahme -100..+100 defines the decrease of speed of the inner track
[steering decrease]
Ebeneschalter A-z Defines the input device on the transmitter that
[Level control] enabled/controls the different levels
Ebenenestellung Defines on which level this output will work
[Level assignment] (use 3 position switch for proper control of the levels)
E+ 0+ A+ works on all levels
E- 0- A+ works just in the upper level(switch up)
E- 0+ A- works just in the mid level(sw. Mid position)
E+ 0- A- works just in the lower level (switch down)
Gegenläufig Nein Normal movement of connected device
[Reverse] [no]
Ja/Invers Ireverse movement of connected device
[Yes/Reverse]
..+SigAus Signal will be switched of after 10 sec downtime
23.06.14 Vxx417