Technical data

GB Sound module USM-RC
34 BEIER-Electronic 28.07.2008
Uploading sounds into the sound module
!!! ATTENTION !!!
If the sound module is only powered via the connected USB-cable, the 7 switching
outputs may not be connected and/or may be switched on.
If attention is not paid to this, the needed current for the connected loads is pulled out
directly from the USB port. This can destroy the USB port of the PC under
unfavorable circumstances!
Put off the ribbon cable from X3 during the programming!
For the upload of new sound files or a changed configuration, you connect the
supplied USB cable to your PC and then to the sound module. The sound module is
supplied with power over the USB port, it must be not powered by an external power
source (battery).
You start the USM-RC Sound-Teacher now and the new sounds can be selected,
and/or make the wanted configuration of the sound module.
Only the complete sound files can always be uploaded into the sound module, not
every sound separately.
Through a click onto the button the file transfer is started.
This can according among of files up to 4 minutes. After the upload, the files are
available in the sound module and can be played. During the transfer of the sound
files, always the configuration of the sound module is transferred automatically.
If only a setting in the configuration is changed, the whole sound files do not need to
be uploaded again. It suffices then to transfer only the configuration. This happens
through a click on the button.
During the transfer to the sound module the red LED flashes.
If an error happens during the transmission, this is shown at the PC. If a transmission
error occurs often, you should restart your PC, close all not needed programs and try
the transfer again.
Attention: The sounds and the configuration cannot be downloaded from the sound
module!