Technical data

D Sound module USM-RC-2
62 BEIER-Electronic 01.03.2012
Configuration - servos
Here you can configure the 2 servo outputs of the USM-RC-2 (see page 44).
If you want to use the servo outputs, you have to switch these on here. However, the
functions of the 2 switching-outputs 11 and 12 would then be disabled.
Home position
The servo drives always in the home position after turning on the sound module.
Positions #1 - #4
These positions can be approached by the freely assigned functions (for example the
proportional inputs # 2 - # 4, the Nautic switches, the EKMFA mode or the switching-
inputs).
To move the positions, click with the mouse on the slider and move the pointer to the
desired position.
Speed
The speed, with which the servo is moved, can be adjusted in 20 steps. It should be
noted that each servo by itself has certain inertia. So even at maximum speed, a
certain amount of time is needed to reach the selected position.
Expanded servo way
The usual length for a standard servo pulse is 1.000 to 2.000ms. Sometimes it is
desirable to expand this area so that the travel is a bit inreased. If this option is
enabled, the servo positions can be set now between 0.700 - 2.300ms.
Caution!
Not every servo may be capable of achieving an expanded way and may get
damaged! Therefore this function has to be taken with some caution.
Go automatically into home position if no other position is selected
If this option is activated, the servo will go automatically in home position if currently
no position #1 - #4 is selected.