Technical data

D Sound module USM-RC-2
52 BEIER-Electronic 01.03.2012
Configuration - General
sound module-configuration
Module mode:
At this point you determine whether the module is to operate in digital, analogue or
mixed mode (see page 7).
For the proportional channel #3 you have the option of operating it in normal mode, in
Nautic mode or in EKMFA mode.
You can also configure the basic volume (10-100%) of the sound module here. This
function is helpful if you don’t have a volume control potentiometer. The volume can
also be adjusted e.g. with a proportional channel configured with the functions
“Volume +“ and “Volume -“.
To receive a more realistic driving sound you can adjust the volume of all sounds
(driving sounds and additional sounds) to the speed. This means the faster the model
drives, the louder the sounds will get. As a result, in stationary the volume will be
lower.
The infrared transmission to the additional light module SM-IR-16-2 can be activated
here. The IR transmission diode is connected to X9.
For troubleshooting while the sound module is running, diagnostic data can be stored
on the SD card. This data can be read out and displayed by the Sound-Teacher (see
page 69).
Warning!
Please only use the diagnosis function for troubleshooting and switch it off right
afterwards!
If diagnosis is activated, the sound playback may be faulty.