Technical data

D Sound module USM-RC-2
42 BEIER-Electronic 01.03.2012
Output “combined back light“
Using the combined rearlight, “parking light“, “brake light“ and “rear fog light“
can be switched using just one output.
The Intensity for each of the 3 lights can be adjusted seperately:
The intensity of the parking light is entered under “intensity“(e.g. 10%).
The intensity of the brake light is entered under “Option 1“(e.g. 30%).
The intensity of the rear fog light is entered under “Option 2“(z.B. 60%).
However, it should be noted that these 3 intensities are added, if more than one light
is switched on. Summing up, you should avoid a value that is over 100%.
Output “in motion on“
This output is always switched on when the model is in motion, whether it is moving
forwards or in reverse.
Output “in stationary on“
This output is always switched on when the model is stationary.
Output “at accelerating on“
This output is always switched on briefly as soon as the model accelerates from rest.
Output “at driving speed on“
This output is switched on when the model exceeds the running speed previously
selected in the Sound-Teacher. The value is entered under “Option 1“.
Outputs “output sequence 1“and “output sequence 2“
You can assign any number of outputs to the output sequences 1and 2. As soon as a
sequence is activated, the outputs are switched based on the programming of the
sequence.