Wireless Industrial Sensor Interface
A secure robust wireless interface with needed for real-Time Industrial Control The BEI SwiftComm wireless industrial sensor interface ushers in a new era of wireless industrial control. Now the machine designer is free to install sensor equipment without the expense and constraints of a hard-wired system. Encoder installations in difficult applications like cranes, rotating tables or mobile applications, are greatly simplified.
SwiftComm’s Unique Advantages Setup and Operation Robust Signal Real Time Control Basic Setup BEI’s SwiftComm operates on the 2.4 GHz ISM radio band and It is critical in any motion control application to have minimum lag The SwiftComm Transmitter and Receiver modules operate as a pair, uses Adaptive Frequency Hopping Protocol (AFH). This helps avoid time in signal transmission. Delays in data to the controller can known as Point-To-Point communication.
Front panel indicators antennas Requirements SwiftComm Transmitter and Receiver Modules has a set of six front panel indicators that show internal operation and RF status. SwiftComm is licensed for use with a 5.5 dBi gain dipole (rubber ducky) with a reverse polarity TNC connector. These antennas are mounted directly to the mating connectors on the SwiftComm modules and are supplied with each Transmitter and Receiver module. the RF Port.
Transmitter swiftcomm Transmitter Module Receiver swiftcomm Receiver module ANTENNA 8.0" OVERALL LENGTH CONNECTOR: RP-TNC CONNECTOR: RP-TNC 1.48 SWIVEL JOINT ANTENNA 8.0" OVERALL LENGTH SWIVEL JOINT Antenna Antenna PWR PWR A A Transmitter B 1.00 50mW 2.4GHz Z 3.13 3.13 LINK STATUS Encoder Input 2.94 Encoder Output CONNECTOR: MS3102R18-1P 2.465 POWER IN CABLE: MENCOM MDC-5FP-2M 2 METERS LG. P/N: 924-31320-K52M CABLE: 10.0' 1.97 2.063 PG9 CABLE GLAND 1.
Security Code Swiftcomm FAQ s SwiftComm radios are paired in a point-to-point configuration. codes are available, assuring no address will ever be repeated. Encoder data is sent from the Transmitter module to the Receiver Additionally, all radio pairs are programmed with their security module, where the data is passed on to the user’s equipment.
United States FCC ID: VSR-SWIFTCOMM11 Canadian IC: 7445A-SWIFTCOMM11 Licensed in US and Canada only To satisfy RF exposure requirements, this device and its antenna must operate with a separation distance of at least 20cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. This device has been designed to operate with an antenna having a maximum gain of 5.5dBi. Antenna having a higher gain is strictly prohibited per regulations of Industry Canada.
