Maintenance Manual
Table Of Contents
- 1 OVERVIEW Marti GTX / GRX
- 2 TECHNICAL SPECIFICATIOINS
- 3 INSTALLATION
- 4 SET UP
- 4.1 Password Organization
- 4.2 Factory Default Passwords
- 4.3 Display Menus and Navigation
- 4.3.1 START & DEFAULT FIELDS
- 4.3.2 TRANSMITTER FIELDS & MENU TREE
- OPERATION MENUS
- Field #02: Direct & Reflected Power
- Field #04: Multiplex Signal Level (Output Modulation)
- Field #05: Left & Right Signal Level in dB
- Field #06: L & R Signal Level / Analog Meter
- Field #07: RDS / SCA Auxiliary Modulation Level
- Field #09: Internal Voltages
- Field #10: Temperature, Data and Clock
- SETUP MENUS
- Field #21: Local/Remote control setup
- Field #22: Transmission Frequency setup
- Field #23: Output Power setup
- Field #24: LF Modulation Input Level setup
- Field #25: Auxiliary Input Level setup
- Field #26: Limiter setup
- Field #27: Transmission Mode, and Pre-emphasis Setup
- Field #28: Reference Deviation setup
- Field #29: Display Contrast setup
- Field #30: Time & Date setup
- Field #31: Elapsed Time
- Field #32: Password Management
- Field #33: Alarm Setup and Display
- Field #34: I/O Pin Allocation and Logic Level setup
- Field #35: Synthesis setup
- Field #37: Ethernet & Lan setup
- 4.3.3 RECEIVER FIELDS & MENU TREE
- OPERATION MENUS
- Field #02: Receiver Frequency
- Field #03: Received RF Field and Muting
- Field #04: MPX Modulation and Reception Field
- Field #04Modulation of the Multiplex Signal
- Fields #05 & #06: L and R Decoded Output Levels
- Field #08: Stereo Pilot Frequency level
- SETUP MENUS
- Field #22: Frequency setup
- Field #24: LF Output Level setup
- Field #25: Receiver Muting setup
- Field #26: De-emphasis setup
- Field #28: Optional Boards Detection
- Field #33: Alarm setup and display
- Field #34: I/O pin allocation and logic level setup
- Field #36 Left & Right Level
- Field #37 Headphone Volume
- Field #39 Serial Number
- 5 SERVICE & CHASSIS DIAGRAMS
34
©2021 Broadcast Electronics
• Field #35: Synthesis setup
SYNTHESIS SETUP
10kHz
This field displays the synthesis step frequency and can be selected,10 or 25kHz
• Field #37: Ethernet & Lan setup
Field #37 is for the ETHERNET & LAN hardware option. The control and display software will have
this ready for the option in both the Transmitter and Receiver. Ethernet settings, IP, Mask and
Gateway may be changed in this field.
ETHERNET & LAN
SETUP
The default settings for Ethernet and LAN are as follows:
IP: 192.168.001.247
Mask: 255.255.255.000
Gateway 192.168.001.250
ID: admin
Password *******