Maintenance Manual
Table Of Contents
- 1 OVERVIEW Marti GTX / GRX
- 2 TECHNICAL SPECIFICATIOINS
- 3 INSTALLATION
- 4 SET UP
- 4.1 Password Organization
- 4.2 Factory Default Passwords
- 4.3 Display Menus and Navigation
- 4.3.1 START & DEFAULT FIELDS
- 4.3.2 TRANSMITTER FIELDS & MENU TREE
- OPERATION MENUS
- Field #02: Direct & Reflected Power
- Field #04: Multiplex Signal Level (Output Modulation)
- Field #05: Left & Right Signal Level in dB
- Field #06: L & R Signal Level / Analog Meter
- Field #07: RDS / SCA Auxiliary Modulation Level
- Field #09: Internal Voltages
- Field #10: Temperature, Data and Clock
- SETUP MENUS
- Field #21: Local/Remote control setup
- Field #22: Transmission Frequency setup
- Field #23: Output Power setup
- Field #24: LF Modulation Input Level setup
- Field #25: Auxiliary Input Level setup
- Field #26: Limiter setup
- Field #27: Transmission Mode, and Pre-emphasis Setup
- Field #28: Reference Deviation setup
- Field #29: Display Contrast setup
- Field #30: Time & Date setup
- Field #31: Elapsed Time
- Field #32: Password Management
- Field #33: Alarm Setup and Display
- Field #34: I/O Pin Allocation and Logic Level setup
- Field #35: Synthesis setup
- Field #37: Ethernet & Lan setup
- 4.3.3 RECEIVER FIELDS & MENU TREE
- OPERATION MENUS
- Field #02: Receiver Frequency
- Field #03: Received RF Field and Muting
- Field #04: MPX Modulation and Reception Field
- Field #04Modulation of the Multiplex Signal
- Fields #05 & #06: L and R Decoded Output Levels
- Field #08: Stereo Pilot Frequency level
- SETUP MENUS
- Field #22: Frequency setup
- Field #24: LF Output Level setup
- Field #25: Receiver Muting setup
- Field #26: De-emphasis setup
- Field #28: Optional Boards Detection
- Field #33: Alarm setup and display
- Field #34: I/O pin allocation and logic level setup
- Field #36 Left & Right Level
- Field #37 Headphone Volume
- Field #39 Serial Number
- 5 SERVICE & CHASSIS DIAGRAMS
13
©2021 Broadcast Electronics
Receiver Review
Like the Transmitter, the Receiver front panel accommodates the single control knob, the display,
four LEDs for immediate status control and a single output connector for IF monitoring.
Here too regular operation is signalized by green LEDs: "PLL Lock" and "Field". This latter is a bi-
stable and lights in yellow when RF field is too low or absent. As in the Transmitter red LEDs signals
improper operation. The first one, "Modulation", is activated by low or absent modulation; the last
one is the general "Alarm" LED.
Figure 3 – GRX Block Diagram