Quick Start Manual

28
L1 N1 L2 N2 L3 N3
Neutral
Phase1
Phase2
Phase3
NeutralPhase
L1 N1 L2 N2 L3 N3
CONFIG.1
CONFIG.2
ph1
ph2ph3
N
230V
ph1
ph2
ph3
N
400V
Quick instructions for commissioning
WARNING: the connection operations of the power supply cable to the equipment ter-
minal boards must be performed with the cable UPLUGGED from the electrical mains or
WITHOUT VOLTAGE exclusively.
Should the operator require to disconnect the equipment from the mains, go backwards
always disconnecting first the electrical plug and then removing the terminals from the
terminal board.
The lines of the three power supplies (L1, L2, L3) must be connected to the three phases, while the three neu-
trals (N1, N2, N3) must be connected with the neutral of the electrical mains.
The lines of the three power supplies (L1, L2, L3) must be connected together to the phase of the electri-
cal mains, while the three neutrals (N1, N2, N3) must be connected together to the neutral of the electrical
mains.
Network configuration available Configuration to be implemented on the transmitter terminal
Configuration to be implemented on the transmitter terminalNetwork configuration available