Quick Start Manual

15
3 Safety
All ELENOS s.r.l products are compliant with the safety standards required for this type
of equipment.
3.1 Precautions
The user must follow also the precautions listed below:
• The original configuration of the equipment must absolutely not be modified. Upon
receipt, check that the supply is compliant with the order specifications and if not,
report it to ELENOS s.r.l. immediately.
• Protective devices must not be disconnected, altered or modified without authoriza-
tion (except for their replacement).
• Check all protective devices periodically and after a failure (e.g. devices against
excess voltage, against excess currents, circuit breakers, etc.).
• For the safety of personnel and to guarantee the integrity of the equipment, it is
absolutely forbidden to operate it and/or handle it with open doors and/or without
its protection panels (even partially) and/or without the earth connection, which
must always be of high quality and compliant to applicable laws. It is further forbid-
den to disconnect and/or alter the protective devices on the equipment.
• Before starting any operation, the equipment must be disconnected from the
mains. Disconnection must be verified by a visual check.
• The equipment must be powered only at the appropriate voltage. Incorrect power
voltage can cause irreparable damage to the equipment and the operator. This
information can be found on the product nameplate, which is usually located on its
casing. In no case must the nameplate be removed, even if the equipment is resold.
• The equipment must be powered by an electrical system which is compliant with
applicable law.
• Other pictograms can be found on the equipment indicating the safety warnings
which must be carefully followed by any operator. Failure to do so releases the
Constructor from any liability for damages/injuries which may result to people or
properties and makes the operator responsible for them.
Hazardous voltage
Safety