User's Manual

11
©2013 Broadcast Electronics
Web Page 4
The STXe comes standard with a built in HTTP web server. To load the web page, simply direct a
standard web browser to the IP assigned to the Ethernet port on the system.
Figure 5 – Web Interface Main Page
The basic settings and monitoring fields in the system are shown above in Figure 5 – Web Interface.
To cycle through the active user selection click the “Current User” link in the upper left. To access PA
monitoring information or the event log click on “PA STATUS” or “EVENT LOG” links respectively.
These can be seen in Figure 7 and Figure 8.
Posting any settings to the exciter requires an appropriate login. The graphic button objects are
disabled for user types that do not have permission to modify exciter settings. Once an adequate user
selection is made, the buttons can be clicked to display any additional options. When the change is
attempted a dialog box will pop up, which can be seen in Figure 8. Simply enter the active user type
and the correct 8-digit numerical password that goes with it to save the setting. Note: password
entry times out after 10 seconds and must be entered on the next new settings change attempt.
Valid login is remembered for the active session.
Figure 6 – Web Interface Authentication