User's Manual

3. Pop the board assembly off the four corner snaps. Set the board about an inch to the

side to the position shown in Figure 35.

Figure 34 – DC Regulator Snaps

4. Pinch the latches on the now easily accessed red connector and pull the cable.

Figure 35 – DC Regulator Cable Latch

With the replacement DC regulator board assembly, repeat the previous steps in reverse.

Note that step 4 can be performed when plugging in the other cables in step 1 when

assembling.

If the cables come unseated from the internal chassis wall, reset them according to the

details in Figure 45 at the end of the next section.