User's Manual

41
©2013 Broadcast Electronics
3. Hold the board assembly by the edges of the board and the heat sinks. When holding
by the edge avoid curling fingers around to the bottom. Remove both of the top screws
and lift the module out of the chassis.
Figure 24 – Safe Fan Power Supply Removal
With the replacement power supply module, repeat the previous steps in reverse. The cable
latches should engage themselves when the cables are fully plugged. Ensure solid latching
on all cables is made.
5.5 Fan
380-9008-001 1 Fan with Connector, 24V 80 mm X 38 mm
Tools
Phillips Screwdriver
1. Slide the fan assembly straight up and out of the chassis and disconnect the cable
harness - pinch latches on both connectors and then pull apart.
Figure 25 – Fan Assembly Removal