User's Manual

35
©2013 Broadcast Electronics
2. Navigate to the SCA/RDS menu.
< SCA/RDS >
TRANSMITTER CONTROL CENTER
3. Select the desired SCA/RDS input and change the setting to ON.
SCA/RDS
TRANSMITTER CONTROL CENTER
SCA1 OFF
SCA1 ->ON
TRANSMITTER CONTROL CENTER
^
4. Navigate to the audio level menu.
< AUDIO LEVEL >
TRANSMITTER CONTROL CENTER
5. Select the desired input and adjust until the displayed composite peak hold is
approximately 10%. Note that enabled SCA1, SCA2, RDS, and composite input signals
all contribute to this peak hold value. Other sources should be turned off for calibration
of each individual channel.
AUDIO LEVEL
TRANSMITTER CONTROL CENTER
SCA1->-12.00dB
SCA1->-12.00dB
TRANSMITTER CONTROL CENTER
9.9% ^