User's Manual
Table Of Contents
29
©2013 Broadcast Electronics
4.7 Turn on AC
1. Unlock AC main breaker on the service line and turn the switch to the on position.
2. Turn on all transmitter circuit breakers.
3. Flip the Power Switch to the on position on the STXe unit.
4.8 Ethernet/IP Network
IP network features are entirely optional. System setup sections below contain procedures
based on the LCD interface on the front panel of the main assembly, but there is alternative
user interfacing for control of all of these setup parameters in both the web and SNMP
interfaces. If utilization of these features is desired, follow these steps:
4.8.1
Dynamic Host Control
1. Connect an Ethernet cable to networking equipment (such as a switch or gateway).
< ETHERNET/IP >
TRANSMITTER CONTROL CENTER
2. Using the transmitter control center on the front panel of the main assembly,
navigate to the ETHERNET/IP menu.
ETHERNET/IP
TRANSMITTER CONTROL CENTER
DHCP DISABLED
DHCP->ENABLED
TRANSMITTER CONTROL CENTER
^
3. Set DHCP to ENABLED (see below for static IP settings).
4.8.2
Static IP
1. Connect an Ethernet cable to networking equipment (such as a switch or gateway).
< ETHERNET/IP >
TRANSMITTER CONTROL CENTER