User's Manual

27
©2013 Broadcast Electronics
1. Use two of the provided Phillips screws in the screw holes shown to attach standoffs to
the bottom of the board. Note that the side of the board shown is important to avoid
interference with the rail.
Figure 10 – Adapter Standoffs
2. Use a small screwdriver and/or the thumb screws to attach the provided D-Subminiature
cable harnesses.
Figure 11 – Adapter Cables
3. Screw hole spacing is exactly 5 Rack units, so the board can be positioned anywhere
vertically. Carefully insert the assembly in the back of the rack and secure with two
Phillips screws.
Figure 12 – Mounting the Adapter Assembly