User's Manual

Installation and Initial Setup 4

This section covers standard installation requirements. Non-standard installations or optional features

and equipment may be covered in other technical documents. Be sure to check the Operation

Manual or http://www.bdcast.com/information-center/

for details.

ENSURE ALL AC POWER INPUT IS COMPLETELY DISCONNECTED BEFORE ACCESSING

ANY SYSTEM COMPONENTS

4.1 Install in Rack

The STXe60 fits in two EIA rack units. Rack mounting is highly recommended to maximize

safety, quality, and the lifetime of the system; however rack mounting is not absolutely

required for operation. For non-threaded rails attach the provided clips in the lowest and

highest holes of the two selected rack units. Set the STXe in place and use provided screws

to secure the system in the rack.

Figure 4 – Rack Mounting

4.2 Exciter RF Jumper

Use the provided BNC jumper to connect EXC RF OUT to PA RF IN.