User's Manual

13
©2013 Broadcast Electronics
Table 1 - Specifications
Parameter Specification
Physical
Height
Width
Depth
Weight
Outlet Size
2 RU 3.5” (8.89 cm)
19” (48.3 cm) EIA Rack Mount
22.5” (57 cm) including connectors
19lbs (8.6 kg) unpacked
30 in
2
(194 cm
2
), rear of unit
Environmental
Temperature
Altitude
Humidity
-10°C to +50°C
10,000ft (3048M) maximum
95% maximum, non-condensing
Air Capacity
Heat Dissipation
BTU
80 CFM (2.3 m
3/
/Min)
90 W at Rated Output
300 BTU/H at Rated Output
AC Input
Frequency
Power Factor
Surge Protection
47-63 Hz
0.99 typical at 100V, 0.95 typical at 200V
Tested to EN 301 489-1, including Voltage Dips and Dropouts
(Section 9.7B), Voltage Surges (Section 9.8) as well as
conducted immunity and conducted radiation.
Power Consumption
150W (calculated) at Rated Output
Single Phase -
Voltage
90 to 264 VAC Split Phase
RF Output
Power Accuracy
Asynchronous AM S/N
Ratio
Synchronous AM S/N Ratio
+/-5% of Total Output Power Setting
Better than -65 dB (typical -70dB) below referenced to 100%
peak AM
Better than -53 dB (typical -60dB) below referenced to 100%
peak AM 75usec de-emphasis with 75 kHz deviation @ 400
Hz
Impedance
VSWR
FM Only Power
Power Control Precision
Efficiency
RF Output Connector
50 Ohms nominal
Rated Power into 1.5:1 VSWR
5-70W
1W
40% typical AC to RF
Type N, Female
Frequency
Range
Stability
87.5MHz to 108MHz; 10kHz increments
+/-100 Hz factory calibration, +/-4ppm aging/temperature
Modulation
Type
Direct-to-Channel; FM