User's Manual

Overview 1

The STXe FM exciter series is designed to provide a cost effective solution for FM broadcast.

Selected exciter settings such as frequency, expected output power, Ethernet settings, etc. can be

communicated at the time of purchase. After preliminary testing of all systems in the transmitter,

technicians use customer settings and verify full system operation under closer conditions compared

to the intended installation.

IP network interfacing features are optional, and thus not included. Network cables and hardware

depend on the desired networking setup and are relatively common.

For details in operation, please see the STXe – 60 Watt FM Exciters Operation Manual. A copy can be

found in the binder containing this manual that is shipped with all transmitters. For electronic copies

of any technical documentation please visit http://www.bdcast.com/information-center/

and follow

navigation on the left side of the page – authorized login is required for download of technical

documents.

Order for experienced quick installation:

See section 4 Installation and Initial Setup for detailed directions of all of these steps.

1. Install the exciter in a rack – not required but highly recommended

2. Exciter RF coaxial cable

3. Transmitter RF coaxial cable

4. AC power service

5. Active stub

6. Assemble exciter interface adapter and connect (only in select transmitters)

7. Turn on AC power

8. Set Ethernet/IP network settings and connect Ethernet to local networking

9. Set time and date

10. Connect and set up all program services

11. Turn RF on