Owner's Manual

ULTRALINK UL2000B

1.1.5 Online-Registration

Please do remember to register your new BEHRINGER equipment right after your purchase by visiting

www.behringer.com (alternatively www.behringer.de) and kindly read the terms and conditions of our

warranty carefully.

Should your BEHRINGER product malfunction, our goal is to have it repaired as quickly as possible.

To arrange for warranty service, please contact the retailer from whom the equipment was purchased.

Should your BEHRINGER dealer not be located in your vicinity, you may directly contact one of our

subsidiaries. Corresponding contact information is included in the original equipment packaging

(Global Contact Information/European Contact Information). Should your country not be listed, please

contact the distributor nearest you. A list of distributors can be found in the support area of our website

(www.behringer.com).

Registering your purchase and equipment with us helps us process your repair claims quicker and more

efficiently.

Thank you for your cooperation!

2. ULR2000 RECEIVER

2.1 Control elements and connections

In this chapter, different control elements of your ULR2000 will be described, explained in detail,

and you will get useful information on how to use them.

2.1.1 The front

Fig. 2.1: ULR2000’s front side

POWER

To power the ULR2000 on or off, keep the POWER button pressed for at least 2 seconds. To

disconnect the unit from the mains, please unplug the power supply. Make sure the wall power

supply is easily accessible whenever you use the ULR2000. If you mount it in a rack, make sure

that you can easily unplug the wall power supply or an all-pole disconnect switch.

 Please keep in mind: The POWER switch does not entirely separate the unit from the

mains. Please disconnect the power cord from the mains if you won’t be using the unit

for a while.

VOLUME

The output signal level of the receiver can be set using the VOLUME control. If you run the

ULR2000 in a setup with balanced connections, a maximum signal level of 12.5 dBu is

possible; in setups with unbalanced connections, the maximum signal level is 6.5 dBu.

 We would like to point out that high volume levels may cause distortion and high signal

levels in other equipment to which your ULR2000 is connected (e.g. mixing console or

headphones). High volume levels may damage your hearing and/or your headphones/

speakers. Please turn the VOLUME control all the way to the left (very low output signal)

before turning the ULR2000 on. Always make sure that an appropriate volume is set.

2. ULR2000 RECEIVER

DATA-MANFULL_UL2000B_ENG_Rev_A.pmd 04.09.2006, 09:366