Owner's Manual

17
ULTRALINK UL2000B
6. After a second brief blink break, an additional blink code is given as a confirmation:
 Two slow blinks signal that the Auto Mute setting was changed. The transmitter leaves
the programming mode.
 If the setting for Auto Mute could not be stored, the LED blinks quickly 5 times. In this
case, start anew with step 2.
7. Disengage MUTE.
3.2.7 Turning the transmitter off
To turn off the transmitter, press the POWER button for 2 seconds. The LED flashes slowly to show
that the microphone is powering down.
 The transmitter stores the frequency and the channel settings. These parameters are
restored to these same values the next time you turn the unit on.
3.3 Status query
During operation, the parameters "transmission channel", "battery condition", "transmission
frequency", "preset", "Mic Gain" and "Auto Mute" may need to be checked. The statuses can be
monitored without having to turn the transmitter off and back on.
3.3.1 Battery condition and transmission channel
1. Turn the selection switch to 0. The position of the MUTE switch does not matter.
2. Briefly press the POWER button.
3. As is this case when turning the transmitter on, the blink codes flash at a medium rate
indicating the current status:
 battery condition: 1 = battery is nearly empty . . . 5 = battery is fully loaded
 selcted channel: 1 = channel 1 is selected. . . 8 = channel 8 is selected
 If the receiver is not powered on, no status is indicated. Briefly pressing the POWER
button will neither turn the transmitter on nor off!
3.3.2 Transmission frequency
1. Turn the selection switch to 9. The position of the MUTE switch is irrelevant.
2. Briefly press the POWER button.
3. Just like during programming, 6 blink medium-tempo codes indicate the individual digits that
make up the transmission frequency. Individual codes are separated from one another by brief
pauses.
 The value 0 is signaled by a very short blink of the LED, and you will easily tell a
0 from a 1.
 If the receiver is not powered on, no status is indicated. Briefly pressing the POWER
button will neither turn the transmitter on nor off!
3.3.3 Preset
1. Make sure the transmitter is not muted (MUTE switch is set to OFF).
2. Turn the selection switch to 1, 2, 3 or 4 and confirm your selection by briefly pressing the
POWER button.
3. The LED indicates the preset number with the corresponding number of medium-tempo
blinks.
3.3.4 Mic Gain
1. Make sure the transmitter is not muted (MUTE switch is set to OFF).
2. Turn the selection switch to 5 or 6 and confirm your selection by briefly pressing the POWER
button.
3. The LED indicates the Mic Gain status with the corresponding number of medium-tempo
blinks:
3. ULB2000 TRANSMITTER
DATA-MANFULL_UL2000B_ENG_Rev_A.pmd 04.09.2006, 09:3617