User Manual SONIC ULTRAMIZER SU9920 Ultimate Stereo Sound Enhancement Processor
SONIC ULTRAMIZER SU9920 User Manual Table of Contents Thank you........................................................................ 2 Important Safety Instructions....................................... 3 Legal Disclaimer.............................................................. 3 Limited warranty............................................................. 3 1. Introduction................................................................ 4 1.1 Before you get started..............................
SONIC ULTRAMIZER SU9920 User Manual Important Safety Instructions Terminals marked with this symbol carry electrical current of sufficient magnitude to constitute risk of electric shock. Use only high-quality professional speaker cables with ¼" TS or twist-locking plugs pre-installed. All other installation or modification should be performed only by qualified personnel.
SONIC ULTRAMIZER SU9920 User Manual 1. Introduction For connection to the mains use the enclosed power cord with cold connector which complies with the relevant safety regulations. 1.1 Before you get started ◊ Please make sure that all devices are properly grounded. For your own safety, never remove or disable the ground conductors from the devices or on the power cords. The unit must always be connected to the mains outlet with a protective grounding connection. 1.1.
SONIC ULTRAMIZER SU9920 User Manual 2.2 Rear panel (8) (7) (9) Fig. 2.2: Control elements on the rear panel (7) FUSE HOLDER / IEC POWER SOCKET: The mains connection is made via an IEC male socket. It complies with relevant safety regulations. A suitable power cord is included. Replace the fuse with a fuse of the same type. (8) OUTPUTS 1: Balanced XLR sockets and ¼" jacks - these are used to connect amplifiers as well as further signal processors and recording devices.
SONIC ULTRAMIZER SU9920 User Manual 3.1.2 Studio application 3.1.3 Stage operation with instrument amplifiers In a studio environment the SONIC ULTRAMIZER is ideal for mastering to enhance the sound of recordings. The SU9920 can lend your music the professional polish of high-quality productions in just a few steps. Even if you primarily work with a digital audio workstation, you can perform the final mastering with the SU9920 and an external recorder.
SONIC ULTRAMIZER SU9920 User Manual 3.2 Basic operation 4.2.1 Cabling with jack cables Due to the small number of control elements on the SU9920 it is easy to learn to use it. Perform the following steps: To operate the SU9920 in series with other equipment, you will need standard commercial ¼" jack cables, often referred to as instrument cables or patch cables. 1) Connect the unit according to the application as described in section 3.1. These cables have a ¼" TS jack plug at each end.
SONIC ULTRAMIZER SU9920 User Manual Alternatively, you can use professional XLR cables with an XLR socket on one side and an XLR plug on the other side. This cable connection is the most reliable both electrically and mechanically. Balanced use with XLR connectors 2 1 3 input 1 = ground/shield 2 = hot (+ve) 3 = cold (-ve) 1 5.
We Hear You
