Quick Start Guide

52 53Quick Start GuideSTAGE TRI LED BUNDLE ST1
IR Remote Control (Optional)
When using the remote control, the space between the device and the remote control should be kept free of obstacles.
The remote control has a range of 10 meters.
Button Function
ON/OFF Press to turn unit on, press again to turn o
AUTO Activate AUTO mode
PRG
Active Show mode. Use + / - to select the preset program from
Pr00-24
SOUND
Turn Sound Control On/OFF for AUTO and PRG. When ON, press +
/ - to adjust the sensitivity from S001 to S100 *
SPEED
Activates speed setting when AUTO and PRG mode is ON. Use +
/ - to adjust the speed from SP01 to SP99 *
STROBE
Activates strobe. Use + / - to adjust the speed from FS00 to
FS99 *
+ Press to increase the current value. Press - to decrease.
DIMMING
Dimmer can be used in AUTO mode, PRG mode, SOUND mode,
and static color
-
Press to decrease the current value to a minimum value of 0.
Press + to increase
W, A, R, G, B
Select color for dimmer mode (White, Amber, Red, Green, Blue).
Note: A and W are linked to preset color macro, UV is not working
for this unit
1 to 9 Select preset color
Notes
* Each press of +/- increases/decreases by 1, but if held down,
the values change faster.
Remote Control Battery
1. The battery positive (+) should face as shown below.
2. The arrow indicates the plastic lock.
Warning: Do not ingest battery. Chemical Burn Hazard
This product contains a coin/ button cell battery. If the coin/ button cell battery is swallowed or placed inside any part of
the body, it can cause severe or fatal internal burns injuries in just 2 hours or less and can lead to death.
Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the product and
keep it away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate
medical attention.
Button Function
AUTO RUN/PROGRAM Cycle through preset shows
SOUND ACTIVE Turn sound active mode on or o
FREEZE Pause or resume a show
BLACKOUT Turn LEDs on or o
Foot Controller
The supplied foot controller can be used to control the device. Connect the supplied 5-pin cable (5 meters long) from the
foot controller to the connector on the T-Bar.
Note: in master/slave operation, only one foot controller is required. Connect it to the master unit, and the other units will
follow.