Specification Sheet
2 ULTRALINK PRO MX882 Technical Specifications
ULTRALINK PRO MX882
Ultra-Flexible 8-Channel Splitter/Mixer
Ultra-low noise 8 in/2 out line mixer and 2 in/8 out line splitter
Each channel can operate independently in mixer or splitter mode
Usable as 6 in/6 out level matching amplier or direct injection box
Converts levels between -10 dBV and +4 dBu
Extremely wide bandwidth from 5 Hz to 200 kHz for highest signal integrity
6 mono in, 6 mono out, 2 main inputs and 2 outputs
4/8-segment input/output level meters for all channels
High-quality components and exceptionally rugged construction ensure long life
Conceived and designed by BEHRINGER Germany
Block Diagram
MAIN Section
Both main inputs interface via the MAIN INPUT LEVEL control with the input
busas well as with the main outputs. The MAIN OUTPUT LEVEL control
determines the output level of the signals which are summed by the second bus
(i.e., the output bus) and are subsequently routed to the main outputs.
SPLIT Mode
In SPLIT mode, the main input signal is sent via the BALANCE control to
the output buer ampliers of the mono channels, with the LEVEL control
determining the output level of the respective channel. The maximum gain
is+15 dB.
MIX Mode
In MIX mode, the input signals of the mono channels are “collected” via the
LEVEL and PAN controls and are routed to the output bus. In this mode, the LEVEL
control determines the amount of each channel at the output
bus, while the PAN control is responsible for the allocation of the input signal to
the left and right main outputs.
Additionally, the input signal is routed to the respective mono outputs,
i.e., the circuit acts as a matching amplier. The LEVEL control allows for level
compensation of up to +15 dB.