User Manual

8 9ULTRALINK PRO MX882 Quick Start Guide
ULTRALINK PRO MX882 Controls
(EN) Controls
(11)(12)(10) (14)
(16)
(15) (13)
(1)
(2)
(3) (6)(4) (7) (9)
(5) (8)
(1) The MAIN INPUT LEVEL control sets the main
input gain, before the signal reaches the input
bus. In SPLIT mode, the MAIN INPUT LEVEL
control determines the common output level for
all mono outputs.
(2) The 4-digit INPUT LEVEL meter informs you
about theinput level of the main input
within a
range from -24 to +6 dB.
(3) By depressing the MAIN LINK switch you can
route the MAIN INPUT signal to the MAIN OUT.
(4) The MAIN OUTPUT LEVEL control adjusts
the output level applied to the main outputs.
The levels present at the six mono outputs
are
not a ected.
(5) The 4-digit OUTPUT LEVEL meter informs you
about the output level of the main input within a
range from -24 to +6 dB.
(6) This SPLIT/MIX switch sets the respective channel
to SPLITTER or MIXERmode.
(7) The LEVEL control determines the signal level of
the
individual channels. InSPLIT mode, the LEVEL
control sets the output level of the mono
channels. In MIX mode, however, it controls
the amount of the mono channel’s input signal
feeding into the main output section; atthe
same time, the level of the mono
channel can be
determined, whichowing to the maximum
gain of +15 dBallows for converting, e.g.,
home recording levels (-10 dBV) intostudio levels
(+4 dBu).
(8) The 8-digit OUTPUT LEVEL meter informs you
about the output level of each channel within a
range from -24to +1
8 dB.
(9) With the BALANCE/PAN control you can set
the balance between the left and right main
signals. InSPLIT mode, the main input signal is
routed to the mono output, withthe BALANCE
control determining the balance beween the
left and right main signal portions. In M
IX mode,
the mono inputs are mixed and routed via the
LEVEL control to the main outputs, withthe PAN
controls determining the allocation of the mono
inputs to the left and right main outputs.
(10) MAINS CONNECTION.
(11) MAIN INPUTS. These are the main audio inputs
of your ULT
RALINK PRO, available as balanced
XLR connectors. They may feed the mono
outputs of all channels which are operated in
SPLIT mode.
(12) MAIN OUTPUTS. These are the main outputs,
availableas balanced XLR connectors. They may
be fed either by the left and
right main inputs or
by any of the six mono inputs (or a combination
of both).
(13) MONO INPUTS (channel 1 to 4). These are
the monoinputs. Connectiontakes place via
balanced XLRconnectors.
(14) MONO OUTPUTS (channel 1 to 4). These are
the mono outputs, available as bal
anced
XLR connectors.
(15) MONO INPUTS (channel 5 to 6). These are
the mono inputs. Connectiontakes place via
balanced phonejacks.
(16) MONO OUTPUTS (channel 5 to 6). These are
the mono outputs, available as balanced
phone jacks.
Check Out behringer.com for Full Manual