User manual

8 9ULTRALINK PRO MX882 Quick Start Guide
ULTRALINK PRO MX882 Controls
(EN) Controls
(1)
(2)
(3) (6)(4) (7) (9)
(5) (8)
(11)
(10)
(17) (16) (15) (14) (13) (12)
(1) The MAIN INPUT LEVEL control sets the main input
gain, before the signal reaches the input bus. In SPLIT
mode, the MAIN INPUT LEVEL control determines the
common output level for all mono outputs.
(2) The 4-digit INPUT LEVEL meter informs you about
theinput level of the main input within a range from
-24 to +6 dB.
(3) By depressing the MAIN LINK switch you can route the
MAIN INPUT signal to the MAIN OUT.
(4) The MAIN OUTPUT LEVEL control adjusts the output
level applied to the main outputs. The levels present at
the six mono outputs are not aected.
(5) The 4-digit OUTPUT LEVEL meter informs you about
the output level of the main input within a range from
-24 to +6 dB.
(6) This SPLIT/MIX switch sets the respective channel to
SPLITTER or MIXERmode.
(7) The LEVEL control determines the signal level of the
individual channels. InSPLIT mode, the LEVEL control
sets the output level of the mono channels. In MIX
mode, however, it controls the amount of the mono
channel’s input signal feeding into the main output
section; atthe same time, the level of the mono
channel can be determined, which—owing to the
maximum gain of +15 dB—allows for converting,
e.g., home recording levels (-10 dBV) intostudio levels
(+4 dBu).
(8) The 8-digit OUTPUT LEVEL meter informs you about
the output level of each channel within a range from
-24to +18 dB.
(9) With the BALANCE/PAN control you can set the
balance between the left and right main signals.
InSPLIT mode, the main input signal is routed to the
mono output, withthe BALANCE control determining
the balance beween the left and right main signal
portions. In MIX mode, the mono inputs are mixed
and routed via the LEVEL control to the main outputs,
withthe PAN controls determining the allocation of
the mono inputs to the left and right main outputs.
(10) FUSE HOLDER / VOLTAGE SELECTOR.
(11) MAINS CONNECTION.
(12) MAIN INPUTS. These are the main audio inputs of your
ULTRALINK PRO, available as balanced XLR connectors.
They may feed the mono outputs of all channels which
are operated in SPLIT mode.
(13) MAIN OUTPUTS. These are the main outputs,
availableas balanced XLR connectors. They may be fed
either by the left and right main inputs or by any of the
six mono inputs (or a combination of both).
(14) MONO INPUTS (channel 1 to 4). These are the
monoinputs. Connectiontakes place via balanced
XLRconnectors.
(15) MONO OUTPUTS (channel 1 to 4). These are the mono
outputs, available as balanced XLR connectors.
(16) MONO INPUTS (channel 5 to 6). These are the
mono inputs. Connectiontakes place via balanced
phonejacks.
(17) MONO OUTPUTS (channel 5 to 6). These are the mono
outputs, available as balanced phone jacks.
Check Out behringer.com for Full Manual