VCO-CV Tuning Procedure Service Support Document
Music Tribe accepts no liability for any loss which may be suered by any person who relies either wholly or in part upon any description, photograph, or statement contained herein.
Technical specications, appearances and other information are subject to change without notice. All trademarks are the property of their respective owners. Midas, Klark Teknik,
Lab Gruppen, Lake, Tannoy, Turbosound, TC Electronic, TC Helicon, Behringer, Bugera, Auratone and Coolaudio are trademarks or registered trademarks of Music Tribe Global
Brands Ltd. © Music Tribe Global Brands Ltd. 2019 All rights reserved.
MS101 VCO & CV
Calibration Procedures
1) Make sure the Internal CV calibration is nished, then start Output CV calibration.
2) Press “Shift + STEP2” to enter user Output CV calibration mode.
3) Press “HOLD/REST”, select test point A. You need to watch the multimeter to adjust the output voltage.
You can press “KYBD” or “STEP” to adjust the CV value until it close to target level “0 V”.
(Press “STEP1” “STEP2” “STEP3” or “STEP4” to select the speed of adjust “X1” “X2” “X3” or “X4”)
4) Press “RESET/ACCENT”, select test point B.
Press “KYBD” or “STEP” to adjust the CV value until it close to target level “1 V”.
5) Press “ARP/SETEND”, select test point C.
Press “KYBD” or “STEP” to adjust the CV value until it close to target level “3 V”.
6) Press “PATTERN/BANK”, select test point D.
Press “KYBD” or “STEP” to adjust the CV value until it close to target level “5 V”.
7) Press “REC” to save and nish Output CV calibration.
2.3 External CV Calibration
1) Make sure the Output CV calibration is nished, then connect the CV out jack to the CV in jack with
a 3.5 mm cable.
2) Press “Shift + STEP3” to start External CV calibration.
3) Wait for the calibration to be nished till all the sequencer LEDs are lit up.
4) All calibration have done. Power o/on MS-101.