Quick Start Guide

54 55Quick Start GuideLED FLOODLIGHT BAR 240-8 RGB-R
The device can be controlled in the following ways:
1. Master/slave
2. IR remote
3. DMX control
Master/Slave Control
Master/Slave, automatic setting
1. Connect the device(s) with DMX cable.
2. Master/slave mode will be activated automatically, master unit will be set randomly.
Master/Slave, manual setting (Slave 1 mode operation)
1. Connect the device(s) with DMX cable.
2. Set the master unit:
2.1. Press MENU of the rst device and select
2.2. Press ENTER
2.3. Then use up and down to select
2.4. Press ENTER (now the rst unit is the master)
2.5. Press MENU on the master device and select . In master and stand alone you can also select one of the modes
/ / /
2.6. Press ENTER
2.7. Select MENU on the master device and select one of the modes
2.8. Press ENTER
2.9. After 5-10 seconds of inactivity, the show mode will be activated
3. Set the slave unit(s):
3.1. Press MENU and select and then select . (same operation on all the slave units)
3.2. Press ENTER
3.3. When connecting the devices with DMX cable, the DMX LED is on.
Controlling the Device
IR Remote Control
When using the remote control, the space between the device and the remote control should be kept free of obstacles.
The remote control has a range of 10 meters.
Button Function
ON/OFF Press to turn unit on, press again to turn o
AUTO Activate AUTO mode. Use +/- to select repeat loop of preset
N 0 - 100
PRG Active Show mode. Use +/- to select
preset program from PRG 0-21
SOUND Turn Preset Show Sound Control On/OFF.
When ON, press +/- to adjust the sensitivity from 0 to 100*
SPEED Activates speed setting when AUTO and PRG mode is ON.
Use +/- to adjust the speed from S001 to S099*
STROBE Activates strobe. Use +/- to adjust the speed from 0 to 100*
+ Press to increase the current value to a maximum value
of 100. Press - to decrease
Dimming Dimmer can be used in AUTO mode, PRG mode,
SOUND mode, and static color
- Press to decrease the current value to a minimum value of 0.
Press + to increase
W, R, G, B Select color for dimmer mode (White, Red, Green, Blue)
Note: A, UV not available for this unit
7, 8, 9 Select preset color. Note: 1 to 6 not avaliable
Notes *Each press of +/- increases/decreases
by 1, but if held down, the values
change faster
Remote Control Battery
1. The battery positive (+) should face as shown below.
2. The arrow indicates the plastic lock.