Quick Start Guide

(EN) Controls
MINIFEX FEX800 Controls
8 MINIFEX FEX800 9 Quick Start Guide
(2)
(1)
(8)
(3) (4) (5) (6) (7) (9) (10)
(11) (12) (14)(13)
(1) The two LED displays show the eect preset currently selected.
One LED is assigned to each preset.
(2) Use the PRESETS control to select one of the 16 eect presets.
(3) The EDIT control allows you to edit one eect parameter.
Thecenter position corresponds to the default setting
programmed for the preset.
(4) The TAP/SELECT button performs two functions:
• TAP (tempo entry): Hit the button several times in
the tempo of the music piece to adapt the delay time of
presets 9 and 15 or the modulation speed of presets 10-12.
The button starts ashing in the corresponding tempo.
• SELECT (additional eect parameter):
Pressthisbutton to choose between two dierent
eect characteristics when using presets 1-8,
13-14,16. Whenthe button lights up this means that
the corresponding parameter of the selected preset
hasbeenactivated.
(5) Use the INPUT LEVEL control to adjust the input signal level.
Please be sure to set a level that is suciently high but does not
overload the unit.
(6) The L + R LED display is for monitoring the input level.
Itcomprises 6 LEDs. When the CLIP LED lights up, this indicates
that digital distortion may occur at the input of the FEX800.
Inthis case, the input signal level must bereduced.
(7) Use the MIX BALANCE control to adjust the ratio of original
vs.eect signal. Turn the control fully to the right to hear only
the processed eect signal. Turn it fully to the left to hear only
the unprocessed input signal.
(8) The IN/OUT button enables/disables the eect signal.
Thebutton lights up when the input signal is being processed
by the FEX800. In order to hear the processed signal you have
toset a suitable ratio of eect vs. direct signal using the
MIXBALANCE control (7).
(9) Use the OUTPUT LEVEL control to adjust the output level.
(10) The � switch turns your MINIFEX FEX800 on and o. The switch
lights up when the unit is switched on.
(11) The FEX800 is connected to the mains using a 2-pole
POWERconnector jack. A matching mains adaptor is
includedwith the unit.
(12) A single footswitch can be connected to the IN/OUT connector.
Thisfootswitch allows you to remotely control the IN/OUT
button (8) on the front panel and switch the eect signal
onando.
(13) The two OUTPUT connectors are on ¼" connectors and provide
a balanced left/right signal.
(14) The two INPUT connectors are on ¼" connectors and can be
used for unbalanced signals. A single mono signal should be
connected to the L jack.
Check Out behringer.com for Full Manual
Front panel control elements of the FEX800 Rear panel connectors of the FEX800