OUTP UT2 CV N OR OUTP UT1 M MIN VOL 0 10 Quick Start Guide FCV100 Ultra-Flexible Dual-Mode Foot Pedal for Volume and Modulation Control
FCV100 User Manual Table of Contents Thank you............................................ 2 Important Safety Instructions........... 3 Legal Disclaimer.................................. 4 Limited Warranty................................ 4 1. Safety Precautions.......................... 5 2. Control Elements............................ 5 3. B attery Installation & Replacement................................ 6 4. Connections.................................... 7 5. Specifications.......................
FCV100 User Manual Important Safety Instructions Terminals marked with this symbol carry electrical current of sufficient magnitude to constitute risk of electric shock. Use only high-quality professional speaker cables with ¼" TS or twist-locking plugs pre-installed. All other installation or modification should be performed only by qualified personnel.
FCV100 User Manual At the same time, your cooperation in the correct disposal of this product will contribute to the efficient use of natural resources. For more information about where you can take your waste equipment for recycling, please contact your local city office, or your household waste collection service. 17. Do not install in a confined space, such as a book case or similar unit. 18. Do not place naked flame sources, such as lighted candles, on the apparatus. 19.
FCV100 User Manual 1. Safety Precautions Detailed safety precautions: Please read all safety precautions and operating instructions before you attempt to operate the unit. Follow all safety precautions and keep operation instructions for future reference. Damage: Take care not to drop your FCV100 as this can lead to severe damage. BEHRINGER assumes no liability for any damage caused by the user.
FCV100 User Manual (4) By using the pedal in the NORM mode, you control the volume level in both channels. In CV mode, the pedal controls OUTPUT 2 for a remote control of parameters such as sound or effects. (5) (6) Fig. 2.2: FCV100 controls (part 2) (5) When the battery LED indicator dims or does not light up, you need to replace the battery. For instructions on how to replace the battery, please refer to chapter 3 “BATTERY INSTALLATION & REPLACEMENT”.
FCV100 User Manual 4. Connections Unbalanced ¼" TS connector strain relief clamp sleeve tip sleeve (ground/shield) tip (signal) Fig. 4.1: 1/4" TS connector CV mode at Output 2 with 1/4 " TRS connector strain relief clamp sleeve ring tip T R Out 2 sleeve ground/shield 50 kΩ tip hot (+ve) Tip: Supply voltage from unit/instrument Ring: Control voltage to unit/intsrument Fig. 4.
FCV100 User Manual 5. Specifications Input/output Maximum input level Input impedance Output impedance Attenuation range Total harmonic distortion Signal-to-noise ratio Power supply Battery power Power consumption Dimensions Weight 1/4" TS connectors, unbalanced Tip: Supply voltage from unit/instrument to be controlled (Impedance: 50 kΩ) Ring: Slider pick-up (control voltage dependend on pedal position (Impedance: 0...50 kΩ) 2 V (RMS) 300 kΩ 560 Ω 0 - 70 dB 0.
Dedicate Your Life to MUSIC
