Quick Start Guide

14 EURORACK GO Quick Start Guide 15
EURORACK GO Pin Outs
Zones
16 POLES, 2 ROWS, PITCH 2.54 mm
LOOKING INTO
CONNECTOR
LOOKING INTO
CONNECTOR
GATE CV +5V +12V GROUND -12V
GATE
CV
+5V
+12V
GROUND
-12V
ZONE A
ZONE C ZONE B
+12 VDC supply regulator IC3
Maximum Output 1A
+12 VDC supply regulator IC2
Maximum Output 1A
+12 VDC supply regulator IC1
Maximum Output 1A
+12 VDC Supply
CAUTION: Do not exceed 1A for each Zone A, B, or C
+5 VDC Supply
CAUTION: Do not exceed 1A total (Zones A+B+C)
-12 VDC Supply
CAUTION: Do not exceed 1A total (Zones A+B+C)
Behringer MODEL D
EURORACK GO Module Example
400 mm ± 10
12
910
1
15
2
16
Ribbon Cable supplied with MODEL D
WARNING: make sure the EURORACK GO is
disconnected from its power supply adapter
before making any connections
Connect End P1 to connector X23 on the MODEL D PCB
Connect End P2 to any connector on the EURORACK GO
CAUTION: Due to the power requirements of the MODEL D, do not connect any other modules to the
same Zone (A, B, or C) on the EURORACK GO
P1 P2
GATE*
CV*
+5V*
+12V
GROUND
-12V*
*(not connected to MODEL D)
Red Stripe