Quick Start Guide

Specications
MA4008 MA4000M
Audio Inputs
Mic / Line Inputs 1 & 2
Type
2 x XLR / ¼" TRS combo jacks
2 x 4-pin Euroblock in parallel
Impedance
Mic: -50 to 0 dBV, 600 Ω
Line: -27 to 0 dBV, 600 Ω
Electronically balanced
Mic / Line Inputs 3 & 4
Type
2 x XLR / ¼" TRS combo jacks
2 x 3-pin Euroblock in parallel
Impedance
Mic: -50 to 0 dBV, 600 Ω
Line: -27 to 0 dBV, 600 Ω
Electronically balanced
Inputs 5 - 8
Type 4 x 3-pin Euroblock, electronically balanced
Impedance
Mic: -50 to 0 dBV, 600 Ω
Line: -27 to 0 dBV, 600 Ω
Auxiliary
Type 4 x RCA stereo summed
Impedance -10 dBV, 10 kΩ, unbalanced Line: -10 dBV, 10 kΩ, unbalanced
Tel / Page input 1 x 4-pin Euroblock
Impedance
Mic: -50 to 0 dBV, 600 Ω
Line: -27 to 0 dBV, 600 Ω
Power amp input 1 x dual RCA jack
Impedance 0 dBV, 600 Ω, unbalanced
Phantom power
24 VDC, switchable
Inputs 1– 8 and Tel/Page
Audio Outputs
Amplier output 1 x 4-pin female Euroblock
LO-Z 2 terminals @ 4 Ω
HI-Z 2 terminals @ 70 V / 100 V, switchable
Output regulation < 2 dB, no load to full load
Main mix outputs 1 & 2 2 x 3-pin male Euroblock, Mic/Line switchable
Impedance
Mic: -40 dBV, 1 kΩ
Line: 0 dBV, 600 Ω
Electronically balanced
Preamp output 1 x dual RCA jack
Impedance 0 dBV, 600 Ω, unbalanced
Z2 / Mon output 1 x dual RCA jack
Impedance 0 dBV, 600 Ω, unbalanced
Record output 1 x dual RCA jack
Impedance 0 dBV, 600 Ω, unbalanced
Amplier
Amplier channels
LO-Z: 1 x 4 Ω, minimum
HI-Z: 1 x 70 / 100 V, switchable
Power output LO-Z 1% THD,
1 kHz sine wave
80 W RMS @ 8 Ω
160 W RMS @ 4 Ω
Min. impedance 4 Ω
Power output HI-Z 1% THD,
1 kHz sine wave
80 W RMS @ 70 V
80 W RMS @ 100V
Min. impedance
62 Ω @ 70 V
125 Ω @ 100 V
MA4008 MA4000M
System Information
Dynamic range
Mic: 65 dB
Line: 80 dB
THD+N 0.5% @ 1 kHz, rated output
Frequency response 50 Hz - 18 kHz, +/- 2 dB
Tone controls
Low: +/- 12 dB @ 100 Hz
High: +/- 12 dB @ 10 kHz
Control Connections
Remote 1 x 5-pin Euroblock connector
Volume 10 kΩ linear-taper potentiometer
Power +5 VDC voltage make contact input; no open voltage
Mute
No-voltage make contact input; open voltage 5 VDC
Short circuit: < 10 mA
DC power
+5 VDC, 100 mA
Current limited, short-circuit protected
Tel / Page 1 x 4-pin Euroblock, 1 terminal
Mute
No-voltage make contact input; open voltage 24 VDC
Short circuit: < 10 mA
Inputs 1 & 2 2 x 4-pin Euroblock, 1 terminal each
Mute
No-voltage make contact input; open voltage 24 VDC
Short circuit: < 10 mA
Indicators
Power LED ring illumination (Yellow)
Overload / protection LED ring indication (Red)
Output level LED VU output meter (Yellow and Red while clipping)
Power Supply (Fuses)
Mains voltage Switchable, 100 ~ 120/220 ~ 240 VAC, 50/60 Hz 100 ~ 240 VAC, 50/60 Hz
Fuse T 5 AH 250 V / T 2.5 AH 250V T 1 AH 250 V
Power eciency 68% (max.)
Power consumption
52 W @ idle
70 W @ ⁄ power
113 W @  power
234 W @ full power
26 W
Mains connector Standard IEC receptacle
Dimensions / Weight
Dimensions (H x W x D)
appr. 3.5 x 17 x 16"
appr. 88 x 432 x 406 mm
Weight appr. 13.4 lbs / 6.1 kg appr. 10.2 lbs / 4.6 kg
32 33Quick Start GuideEUROCOM MA4008/MA4000M