Version 1.
EUROPOWER EP1500/EP2500 IMPORTANT SAFETY INSTRUCTIONS DETAILED SAFETY INSTRUCTIONS: 1) Read these instructions. 2) Keep these instructions. 3) Heed all warnings. 4) Follow all instructions. CAUTION: WARNING: To reduce the risk of electric shock, do not remove the top cover (or the rear section). No user serviceable parts inside; refer servicing to qualified personnel. To reduce the risk of fire or electric shock, do not expose this appliance to rain and moisture.
EUROPOWER EP1500/EP2500 EUROPOWER High-end power amp with optional bridge mono operation mode for live applications EP1500/EP2500 s 2 x 700 Watts (EP2500: 2 x 1200 Watts) into 2 Ohms, 1400 Watts (EP2500: 2400 Watts) into 4 Ohms bridged operation s 2-channel, parallel or bridged mono operating modes for flexible application s Independent limiters for each channel offer dependable protection against distortion s Precise signal and clip LED indicators to monitor performance s Selectable low-frequency filt
EUROPOWER EP1500/EP2500 TABLE OF CONTENTS FOREWORD Dear Customer, welcome to the team of BEHRINGER users, and thank you very much for expressing your confidence in us by purchasing this power amplifier. Writing this foreword for you gives me great pleasure, because it represents the culmination of many months of hard work delivered by our engineering team to achieve a very ambitious goal: to develop two outstanding power amplifiers, whose flexibility lets them respond to all the P.A.
+ EUROPOWER EP1500/EP2500 If the unit is damaged, please do NOT return it to BEHRINGER, but notify your dealer and the shipping company immediately. Otherwise, claims for damage or replacement may not be granted. Please make sure the unit is provided with sufficient ventilation, and never place your EUROPOWER amp on top of other heatemanating equipment or in the vicinity of a heater to avoid the risk of overheating. The mains connection is made via the enclosed power cord and a standard IEC receptacle.
EUROPOWER EP1500/EP2500 + To prevent faulty operation, please assure that the unit is kept at a distance from other appliances emanating heat. Switches 2 (ch. 1) and 9 (ch. 2) determine the cut-off frequency. As long as the filter is disengaged, frequencies below 5 Hz are cut to prevent damage. These are the Speakon® outputs (channels 1 and 2). When running the unit in mono-bridged mode (see chapter 2.3.5), please use the channel 1 output exclusively.
EUROPOWER EP1500/EP2500 3. APPLICATIONS + Running EUROPOWER amplifiers in conjunction with 8-Ohm speakers with a power rating of at least 2 x 260 Watts (EP1500) and 2 x 450 Watts (EP2500) is recommended to assure optimal operation. 3.1 Differences between 2-channel, parallel and mono-bridged operating modes 2-channel mode is the most common operating mode of amplifiers. Both channels operate fully independently from one another. There is always a separate input signal as well as a separate output signal.
EUROPOWER EP1500/EP2500 Fig. 3.4: DIP switch positions for parallel operation When running in mono-bridged mode, the voltage of both channels is added up and fed into a single loudspeaker system. There is one input and one output signal respectively, and only the controls of channel 1 (and not of channel 2) are used. + Fig. 3.
EUROPOWER EP1500/EP2500 The BEHRINGER EUROLIVE SERIES loudspeakers are an outstanding solution for expanding your P.A. system, because each frequency range/application has a speaker type that optimally suits its characteristics. + Extreme clip limiter settings in bi-amp operating mode can result in balance shifting. 4. INSTALLATION Your EUROPOWER can be installed into a 19" rack and requires two rack units. Please use four attaching screws and washers for installation.
EUROPOWER EP1500/EP2500 When using binding post connectors, please make sure that insulation on cables is not removed too high. Insert the naked part of the cable fully so that no metal is visible. Cable clamps must be isolated to avoid the possibility of electric shock. When running the amp in mono-bridged mode, always use the middle two binding post connectors, paying attention to correct polarity.
EUROPOWER EP1500/EP2500 5. SPECIFICATIONS (3 (3 8 Ω per channel 260 W 450 W 4 Ω per channel 400 W 650 W 287387 32:(5 20 Hz - 20 kHz @ 0.1% THD, both channels driven: 1 kHz @ 0.1% THD, both channels driven: 8 Ω per channel 280 W 500 W 4 Ω per channel 450 W 750 W 2 Ω per channel 700 W 1200 W 800 W 1300 W Bridged Mono: 8 Ω, 20 Hz - 20 kHz, 0.1% THD 8 Ω, 1 kHz, 0.1% THD 900 W 1500 W 4 Ω, 1 kHz, 1% THD 1400 W 2400 W ',67257,21 )5(48(1&< 5(63216( < 0.
EUROPOWER EP1500/EP2500 6. WARRANTY § 1 WARRANTY CARD/ONLINE REGISTRATION To be protected by the extended warranty, the buyer must complete and return the enclosed warranty card within 14 days of the date of purchase to BEHRINGER Spezielle Studiotechnik GmbH, in accordance with the conditions stipulated in § 3. Failure to return the card in due time (date as per postmark) will void any extended warranty claims.
