User`s manual

15
E
you determine the sensitivity of the dynamic high cut filter. This function is highly useful to remove noise from
the music signal. To indicate that the sensitivity is being edited the SENS LED beside the numeric display
lights up.
+ The optimal adjustment of the SENSITIVITY parameter depends strongly on the type of noise
and program material. Take the time to set the SENSITIVITY parameter with care.
2.1.7 The Crossover parameter
The advantage of multiband processing is in the division of the audio spectrum into several bands, in order to
avoid the negative effects of spectral intermodulation. The choice of the crossover frequency which divides
the bands has influence on how the processing takes place. With complex composite signals the crossover
frequency should be in the bass area (±200Hz e.g. in order to prevent modulation of the mid and high fre-
quency range by the energy produced in the bass area). With single instruments and vocals however, a higher
crossover frequency is more desireable (2kHz), since the center point of the power spectrum is shifted here.
For complete flexibility the crossover frequency can be set anywhere from 20Hz to 20kHz, in 31steps
according to the ISO frequencies. This enables the ULTRAMIZERPRO to be used not only as a mastering
device but also as a processor for single instruments and vocals. If you set the crossover frequency to the
maximum or minimum value (20Hz or 20kHz), the ULTRAMIZERPRO will operate as a broadband compres-
sor.
Feel free to experiment with different crossover frequency settings and pretty soon a feeling for the right
setting will arise, making the ULTRAMIZERPRO that much more effective and useful.
2.2 Selecting presets
The ULTRAMIZERPRO stores 50 user-definable presets. After power-up, the unit automatically recalls the
preset last used. To select another preset, make sure that the PRESET key is pressed once. Use the jog
wheel to enter the preset number of your choice. Turn the wheel clockwise to increment the preset number, or
counter-clockwise to decrement it.
+ Please note that the ULTRAMIZERPRO generally activates the newly selected presets only
after about one second, which is indicated by a dot in the lower right corner of the display.
After loading the data, the ULTRAMIZERPRO enables the preset and the dot disappears. This
brief interruption avoids the direct activation of every preset, as you scroll through the preset
list with the jog wheel. Thus, the ULTRAMIZERPRO makes sure that no "unwanted" presets
are loaded unintentionally. Additionally, you can rotate the jog wheel at high speed and still
have the time to specifically select the preset of your choice, instead of any of its "neighbors".
2.3 Editing presets
Editing presets is easy on the ULTRAMIZERPRO. Basically, all essential parameters can be selected directly
via the keypad and edited with the jog wheel. Some key have multiple function that can be accessed by
pressing that particular key repeatedly.
Use the LEFT and RIGHT keys to edit the left or right audio channel settings. Of course, you can edit both
channels at the same time in COUPLE mode.
+ Whenever you edit one of the two audio channels and then switch to couple mode, the param-
eters of the active channel will be copied to the other; i.e. if you press LEFT before RIGHT, left
will be copied to right. Finally, you can also save the edits made to the preset.
2.4 Saving presets
Use the PRESET key to save an edited preset. Basically, all parameter changes can be saved. Whenever
youre editing a preset, the display starts flashing to indicate that the edits will be saved only when you
confirm them by pressing the PRESET key twice. Example:
s
You recall a preset for editing. Then you edit the preset as desired using the function keys and the jog
wheel. During this process, the flashing PRESET key reminds you that the preset settings have been
changed but not saved yet. Press the PRESET key once. The display reads the current preset number.
When pressed again this number starts flashing. To keep the original preset, use the jog wheel to select
2. OPERATION