User Manual

62 DeepMind 12 User Manual
P. MO D -SR C - This option allows you to select the source for the amount of PITCH
MODULATION from the following:
•
• LFO-1 - Bipolar use of the LFO 1 waveform.
•
• LFO-2 - Bipolar use of the LFO 2 waveform.
There is also a visualization of the modulation as shown below. The arrows
indicate the polarity of the modulation..
•
• ENV-1 - Bipolar use of the ENV 1 envelope.
•
• ENV-2 - Bipolar use of the ENV 2 envelope.
•
• ENV-3 - Bipolar use of the ENV 3 envelope.
Note: In the visualization for ENVELOPE sources the arrow will only point in the
UP direction indicating that the modulation will be positive from the base pitch.
•
• LFO-1(Uni) - Unipolar use of the LFO 1 waveform.
•
• LFO-2(Uni) - Unipolar use of the LFO 1 waveform.
Note: In any of the Unipolar (Uni) modes the waveform is only used for positive
modulation.
The default setting for the P.MOD-SRC is LFO-1.
Note: In the visualization for Uni-polar LFO sources the arrow will only point in
the UP direction indicating that the modulation will be positive from the base
pitch.
The default setting for the P.MOD-SRC is LFO-1.
AFT>P.MOD - This option controls how much PITCH MODULATION is increased
by AFTERTOUCH pressure. This allows you to expressively control the PITCH
MODULATION and its e ect using key pressure.
The AFT>P.MOD range is from 0-255, and the default setting is 0 (O ).
WHEEL>P.MOD -This option controls how much PITCH MODULATION depth is
increased by the MOD WHEEL position. This allows you to expressively control the
PITCH MODULATION and its e ect using the MOD WHEEL.
The MOD WHEEL>P.MOD range is from 0-255, and the default setting is 0 (O ).
T.MOD-SRC - This option allows you to select the source for the amount of TONE
MODULATION from the following:
•
• MANUAL - In this mode the TONE MOD fader is used to manually adjust the
PWM.
•
• LFO-1 - Bipolar use of the LFO 1 waveform. In this mode the TONE MOD fader
is used to adjust the amount of modulation from 0 to +/- 49%.
•
• LFO-2 - Bipolar use of the LFO 2 waveform. In this mode the TONE MOD fader
is used to adjust the amount of modulation from 0 to +/- 49%.
OSC 2 PITCH MODULATION AMOUNT (LFO AS SOURCE)
OSC 2
LFO (SIN)
PITCH MOD LOW
PITCH MOD MED
PITCH MOD HIGH
OSC 2 PITCH MODULATION AMOUNT (ENVELOPE AS SOURCE)
OSC 1 (SQR)
ENVELOPE
ATTACK DECAY
SUSTAIN
RELEASE
PITCH MOD
OSC 2 PITCH MODULATION (UNIPOLAR LFO AS SOURCE)
OSC 1 (SQR)
PITCH MOD
LFO (SIN)
UNIPOLAR
OSC 2 TONE MODULATION (LFO AS SOURCE)
OSC 2 (SQR)
LFO (SIN)
TONE MOD