User Manual

61 DeepMind 12 User Manual
•
• LFO-1 - Bipolar use of the LFO 1 waveform. In this mode the PWM fader is
used to adjust the amount of modulation from 0 to +/- 49%.
•
• LFO-2 - Bipolar use of the LFO 2 waveform. In this mode the PWM fader is
used to adjust the amount of modulation from 0 to +/- 49%.
Note: When an LFO is used as a PWM source, the arrows indicate the range of
modulation as shown below:
•
• ENV-1 - Unipolar use of the ENV 1 envelope. In this mode the PWM fader is
used to adjust the amount of modulation from 0 to +/- 49%.
•
• ENV-2 - Unipolar use of the ENV 2 envelope. In this mode the PWM fader is
used to adjust the amount of modulation from 0 to +/- 49%.
•
• ENV-3 - Unipolar use of the ENV 3 envelope. In this mode the PWM fader is
used to adjust the amount of modulation from 0 to +/- 49%.
Note: When an ENVELOPE is used as a PWM source, the arrows indicate the range
of modulation as shown below:.
P.MOD MODE - This option allows you to select which oscillators are controlled
by the OSC 1 PITCH MOD fader.
Note: It is useful to have both OSCs responding for e ects like tremolo.
•
• OSC1+2 -Both OSCs have PITCH MODULATION applied to them.
•
• OSC1 - Only OSC 1 has PITCH MODULATION applied to it.
KEY-DN-RESET - This option allows you to reset the phase of oscillator waveform
to start from its reset point each time a key is pressed.
The default setting for KEY-DN-RESET is O .
To exit the OSC EDIT menu press the PROG switch to return the main display, or to
continue to the OSC 2 EDIT menu press the OSC EDIT switch again.
8.3.13 OSC EDIT SWITCH (OSC 2)
To access the OSC EDIT menu press the OSC EDIT switch.
The OSC EDIT switch will then start  ashing and the OSC 1 EDIT menu is then
shown. Press the EDIT switch again to show the OSC 2 EDIT menu:
To navigate the options in the OSC 2 EDIT menu, use the UP, DOWN, switches.
Selected parameters are adjusted using the -NO/+YES switches, the rotary knob
or the fader. The rotary knob has a click which allows very accurate control. The
fader allows rapid adjustment across the full range.
8.3.14 OSC 2 MENU
The following options are available in the OSC 2 EDIT menu:
RANGE - This option allows you selects the base pitch of the OSC as follows:
16' - The lowest note on the keyboard (C) is tuned to 16.35 Hz.
8' - The lowest note on the keyboard (C) is tuned to 32.7 Hz.
4'- The lowest note on the keyboard (C) is tuned to 65.4 Hz.
The default setting for the RANGE is 8'.
OSC 1 PULSE WIDTH MODULATION (LFO AS SOURCE)
OSC 1 (SQR)
LFO (SIN)
PWM
OSC 1 PULSE WIDTH MODULATION (ENVELOPE AS SOURCE)
OSC 1 (SQR)
ENVELOPE
ATTACK DECAY
SUSTAIN
RELEASE
PWM
OSC 1 (SAW)
KEY-DN-RESET
OFF
KEY-DN-RESET
ON
OSC 1 KEY DOWN RESET
KEY PRESS KEY PRESS KEY PRESS
FLASHING=EDIT