User Manual

57 DeepMind 12 User Manual
As you increase the amount of TONE MODULATION the positive and negative parts
of the cycle are split by a pulse. The further you increase the fader, the width of
the pulse increases.
The TONE MOD range is from 50%(symmetrical square-wave) to 100% (pulse
interrupt is 60% of half cycle). The default TONE MOD setting is 50%.
The fader position, current value and stored value for the TONE MOD fader is
shown on the PROG screen. There is also a visualization of the waveform as
shown below
Note: for ENVELOPE sources the arrow will only point in the UP direction
indicating the range of modulation. In this mode the TONE MOD fader is used to
adjust the amount of modulation from 0 to +/- 49%
Note: for Uni-polar LFO sources the arrow will only point in the UP direction
indicating the range of modulation. In this mode the TONE MOD fader is used to
adjust the amount of modulation from 0 to +/- 49%.
8.3.7 OSC 2 PITCH FADER
The OSC 2 PITCH fader controls the PITCH of the OSC 2 SQUARE waveform. The
pitch can be tuned to match the pitch of OSC1, o set slightly to create a wider
sound, or o set more to create harmonic overtones.
As you increase/decrease the PITCH fader the pitch of the oscillator will increase/
decrease.
The OSC 2 PITCH range is from -12.0 semitones to +12.0 semitones. The default
OSC 2 PITCH setting is 0 semitones.
The fader position, current value and stored value for the OSC 2 PITCH fader is
shown on the PROG screen. There is also a visualization of the pitch setting as
shown below:
Note: The centre of the line shown on the visualization highlights the  ne
resolution that is available around the centre point. Here the units of adjustment
will change from semitones to cents
TONE MODULATION
50%
62.5%
75%
87.5%
100%
100%
60%
OSC 2 PITCH
0 (KEY PITCH)
-12 SEMITONES
+12 SEMITONES