User Manual

50 DeepMind 12 User Manual
The fader position, current value and stored value for the LFO DELAY TIME fader is
shown on the PROG screen. There is also a visualization of the waveform as
shown below:
8.2.3 LFO WAVEFORMS INDICATORS
The LFO waveform shape setting is always shown on the LEDs.
The LFO waveform shape in use will have an illuminated LED next to it.
The LED will glow to show the status of the waveform as shown below:
8.2.4 LFO EDIT MENU
To access the LFO EDIT menu press the LFO EDIT switch.
Shortcut Note: To change the LFO waveform shape press and hold the LFO EDIT
switch. While holding the switch you can use the LFO RATE fader to set the LFO
waveform shape.
The LFO EDIT switch will then start  ashing and the LFO EDIT menu is then shown:
To navigate the options in the LFO EDIT menu, use the UP, DOWN, switches.
Selected parameters are adjusted using the -NO/+YES switches, the rotary knob
or the fader. The rotary knob has a click which allows very accurate control. The
fader allows rapid adjustment across the full range .
SHAPE - This option allows you to select one of the waveform shapes from the
following options (shown with their respective visualization waveforms from the
PROG display).
Sine - A mathematically correct sinusoidal waveform.
Triangle - A symmetrical triangular waveform.
Square - A symmetrical square waveform.
Ramp Up - An up ramping triangular waveform.
Ramp Down - An up ramping triangular waveform.
Smp&Hold (Sample and Hold) - A random stepped waveform which
transitions instantly from step to step.
Smp&Glide (Sample and Glide) - A random stepped waveform which glides
from step to step.
The default LFO SHAPE setting is Triangle.
FULL BRIGHTNESS
HALF BRIGHTNESS
OFF
LFO WAVEFORM INDICATORS
FLASHING=EDIT