User Manual

23 DeepMind 12 User Manual
7.2.9 COPY/PASTE FX SETTINGS
If you need to copy e ects settings from a previously stored e ect, please follow
this procedure.
1) Ensure you have saved any edits you have made to your current program
if required.
2) Load the program which has the e ects settings you intend to copy.
3) Navigate to the 1, 2, 3, 4  ow diagram near the top of the FX screen.
4) Press the FX switch to enter the FX page.
5) Press and hold the FX switch until you see the following message and
the GLOBAL/WRITE switches are  ashing:
6) While continuing to hold the FX switch, press the GLOBAL switch to copy
the e ects settings into memory.
7) Then load the program you intend to paste the e ects settings to.
8) Press the FX switch to enter the FX page.
9) Press and hold the FX switch until you see the following message:
10) While continuing to hold the FX switch, press the WRITE switch to copy
the e ects settings from memory into the program.
Note: All settings relating to e ects will be copied/pasted, these include FX
routing, FX modes and all of the FX slots and their settings.
7.2.10 MOVING EFFECTS
If you need to move an e ect to a di erent slot, please follow this procedure.
1) Ensure you have saved any edits you have made to your current program
if required.
2) Press the FX switch to enter the FX page.
3) Navigate to the e ects slot you wish to move.
4) Press and hold the FX switch until you see the following message and
the BANK UP/DOWN switches begin  ashing:
5) While continuing to hold the FX switch, you can move the e ects slot
to another location using one of these methods:
•
• To move the slot to an adjacent upper slot press the BANK/UP switch.
•
• To move the slot to an adjacent lower slot press the BANK/DOWN switch.
•
• To move the slot to any other slot, turn the rotary knob.
You can continue to move the slot with any of the methods above, the new slot
will be highlighted as shown below:
6) Once you release the FX switch the e ect will be moved to the new slot.
Note: All e ects parameters will be moved with the e ect.