User Manual

21 DeepMind 12 User Manual
7.2 FX (E ects Menu)
The on-board virtual FX Rack provides access to four true-stereo, multi-e ects
processors including delay, chorus, dynamics and production-quality true-stereo
reverbs.
You can select any combination of high-end simulations of legendary studio
e ects.
7.2.1 FX OVERVIEW
To access the FX menu simply press the FX switch:, the FX switch will be
illuminated when you are in this menu.
The display will then show the FX OVERVIEW menu:
To navigate within the FX OVERVIEW menu, navigate within the display menus
using the UP, DOWN, +/YES & -/NO switches.
Selected parameters on the display are adjusted using the rotary knob or the
fader. The rotary knob has a click which allows very accurate control. The fader
allows rapid adjustment across the full range.
The options available in the FX OVERVIEW menu are as follows:
FX ROUTING - At the top of the FX OVERVIEW menu you will see the FX ROUTING
shown as a series of 4 boxes representing the individual e ects.
In order to expand the sonic possibilities of the DSP FX inside the DeepMind 12
there are several routing options for the four slots.
! Warning: The routings with feedback are highly creative,
but as they employ feedback loops, careful consideration should be
made while using them. It is recommended to keep the VOLUME knob in
a low position while experimenting.
FX MODE - This allows you to choose if the e ects are to be con gured in INSERT
MODE, SEND(and Return) MODE, or to BYPASS the e ects.
FX SLOTS - These are the four slots you can load e ects modules into.
MIX - The MIX parameter controls how much of the original sound is blended
with the e ected/processed sound for each FX slot.
LEVEL - The LEVEL parameter controls the output level of any e ects which are
con gured in parallel, or any e ects which are the last e ect before reaching the
output stage.
To exit the FX menu press the PROG switch to return to the main programming
screen.
Note: To reduce the possibility of excessive low frequency build up there is
a 30 Hz High Pass Filter used in the feedback path for routing options which
include feedback.
7.2.2 SELECTING FX ROUTING
To select a routing make sure that the '<' symbol is highlighted next to the
routing diagram, then you can either turn the rotary knob, or use the data entry
fader to select from one of the following routings:
SERIAL 1-2-3-4 (M-1)
PARALLEL 1/2 SERIAL 3-4 (M-2)
PARALLEL 1/2 PARALLEL 3/4 (M-3)
PARALLEL 1/2/3/4 (M-4)
PARALLEL 1/2/3 SERIAL 4 (M-5)
SERIAL 1-2 PARALLEL 3/4 (M-6)
SERIAL 1 PARALLEL 2/3/4 (M-7)
PARALLEL (SERIAL 1-2-3)/4 (M-8)
SERIAL 3-4 FEEDBACK4(1-2) (M-9)
SERIAL 4 FEEDBACK4(1-2-3) (M-10)
!
!