User Manual

12 DeepMind 12 User Manual
4.2.3 Using MIDI Program Change messages
You can change the program using a MIDI program change message. This special
MIDI message can be sent from your Digital Audio Workstation (DAW) or from an
external MIDI device which is capable of transmitting program change messages.
For details on the message please consult the section on MIDI commands.
4.3 Program Categories
Each program is assigned to a category from the list of options below:
•
• NONE - No category information is stored.
•
• BASS - Used for bass sounds.
•
• PAD - Used for pad sounds.
•
• LEAD - Used for lead sounds.
•
• MONO - Used for monophonic sounds.
•
• POLY - Used for polyphonic sounds.
•
• STAB - Used for stab sounds.
•
• SFX - Used for sound e ects.
•
• ARP - Used for programs with the arpeggiator active.
•
• SEQ - Used for programs with sequencing.
•
• PERC - Used for percussion sounds.
•
• AMBIENT - Used for ambient or texture sounds.
•
• MODULAR -Used for programs with modular type programming.
•
• USER-1/4 - Used for user/project speci c sounds..
For information on how to assign a category, please consult the section on
writing programs.
4.4 Browsing by Category
To access the program browser, press and hold the PROG switch.
Note: a help menu will appear while the PROG switch is held, showing additional
guidance and commands:
To change programs, while you have the PROG switch held you can press the
LEFT/RIGHT switches to select the PREVIOUS/NEXT programs within the category.
To change categories, while you have the PROG switch held you can press the UP/
DOWN switches to select the PREVIOUS/NEXT category.
Note: While the PROG switch is held you can still see the category changes
displayed behind the pop-up menu.
4.5 Default Program
In order to return to a  xed point when creating programs you recall a default
program using the short-cut described here. The default program is con gured
without modulation/e ects and uses basic settings in each of the sections.
To load the default program, press and hold the PROG switch, then press the
COMPARE switch.
Note: a help menu will appear while the PROG switch is held, showing additional
guidance and commands.:The default program will then be loaded.
4.6 Revert to Panel
When you load a program, all the physical controls on the DeepMind 12 may not
match the position stored in memory. In order to send all the physical positions
to the program (rather than moving each individually until you reach the
stored value), follow the procedure below:
Warning: When you do this the sound/character of the program will often
change radically as the multiple parameters are updated.
To revert to the panel controls, press and hold the PROG switch, then press the
WRITE switch.
Note: a help menu will appear while the PROG switch is held, showing additional
guidance and commands:
The current program will then be updated with the positions of the physical
controls on the DeepMind 12.