Manual
34 DeepMind 6 User Manual
CALIBRATE PEDAL
To calibrate the PEDAL please use the following process:
Note: During the calibration the GLOBAL, -/NO and +/YES switches will be
ashing. If at any time you want to cancel the calibration routine, you can press
the -/NO switch. No previous calibration data will be changed if you do cancel the
routine. To conrm the calibration at each stage press +/YES as described below.
1. In order to start the calibration routine, make sure that the '<' symbol on the
CALIBRATE PEDAL line is highlighted and press +/YES.
2. You will see the following display showing a bar representing the current
PEDAL value (0% for no pressure). Also on this screen you can see the stored
calibration data above the bar and the current value below the bar:
3. Then press the pedal until the value stops increasing.
4. You will see the following display showing the maximum position of the
PEDAL input and the associated value:
Note: To cancel the routine, press the -/NO switch, and you will see the
following message:
5. To conrm the CALIBRATION of the PEDAL input, press the +/YES switch: The
calibration data will then be stored for the PEDAL and you will be returned
to the CALIBRATE menu. From here you can perform another calibration
from the menu, or press the GLOBAL switch again to return to the SYSTEM
SETTINGS menu.
BACKUP (Backup Menu)
The last item in the SYSTEM SETTINGS menu is BACKUP.
1. Pressing +/YES when “BACKUP -->” is selected, will bring up the BACKUP
MENU. (The "RESTORE BANK" lines only appear after the rst backup is
done).
2. Pressing +/YES when “BACKUP PROGRAMS” is selected, will bring up a
conrmation dialog:
3. Pressing +/YES again, will copy all Banks of programs from EEPROM to ash,
and overwrites the “factory default” data.
4. Pressing +/YES when any of the RESTORE-BANK-A to RESTORE-BANK-H lines
is selected, will bring up a conrmation dialog:
5. Pressing +/YES again will restore the selected bank from ash.
6. Press GLOBAL to return to the SYSTEM SETTINGS menu, and press again to
return to the PROG menu.